The blend of Non-ionic surfactants, Hydrocarbon solvents, and many powerful heavy-duty ingredients for effectively on-line fired wash cleaning of gas turbine compressors. TURBOCLEAN HeavyDuty Hydrocarboncon is a concentrated powerful cleaner for the compressor section of industrial, Marine aviation gas turbine engines. TURBOCLEAN HeavyDuty Hydrocarbon also specialized in on-line fired wash cleaning of gas turbine compressors.
Gas Turbine Compressor Cleaning TURBOCLEAN HeavyDuty Hydrocarbon RXSOL solvent-based cleaners for effective Degreasing, Cleaning of oil deposits and Decarbonising the surface of gas turbine compressors. TURBOCLEAN HeavyDuty Hydrocarbon is SOLVENT based powerful cleaner where as water-based detergents are much less effective.
By spray ring or lance in either starter-driver (off-line) or fired (on-line) wash as directed by the engine manufacturers, in the quantities recommended in the engine manual. It is essential during hot wash that the cleaner should leave as little ash residue as possible to avoid blocking turbine blade cooling holes.
Mix One Part of TURBOCLEAN HeavyDuty Hydrocarbon with 4 PARTS of DI Water for On-line cleaning.
|
pH |
: |
7.5 - 8.5 |
|
Specific gravity |
: |
0.955 |
|
Total alkali metals |
: |
<0.5ppm after dilution |
|
Ash |
: |
<0.01% |
| Flash Point | : | >65 Degree |
|
Solvent Content |
: |
> 55 |
|
Alkyl phenol ethoxylates |
: |
None |
|
Halogens (measured as total Chlorine) |
: |
<10 ppm for concentrate |
|
pH |
: |
7.5 - 8.5 |
|
Specific gravity |
: |
1.01 |
|
Total alkali metals |
: |
<0.5ppm after dilution |
|
Ash |
: |
<0.01% |
|
Aromatic compounds |
: |
None |
|
Alkyl phenol ethoxylates |
: |
None |
|
Halogens (measured as total Chlorine) |
: |
<10 ppm for concentrate |
|
pH |
: |
7.5 - 8.5 |
|
Specific gravity |
: |
1.01 |
|
Total alkali metals |
: |
<0.5ppm after dilution |
|
Ash |
: |
<0.01% |
|
Aromatic compounds |
: |
None |
|
Alkyl phenol ethoxylates |
: |
None |
|
Halogens (measured as total Chlorine) |
: |
<10 ppm for concentrate |
|
pH |
: |
7.5 - 8.5 |
|
Specific gravity |
: |
1.01 |
|
Total alkali metals |
: |
<0.5ppm after dilution |
|
Ash |
: |
<0.01% |
|
Aromatic compounds |
: |
None |
|
Alkyl phenol ethoxylates |
: |
None |
|
Halogens (measured as total Chlorine) |
: |
<10 ppm for concentrate |
|
pH |
: |
7.5 - 8.5 |
|
Specific gravity |
: |
1.01 |
|
Total alkali metals |
: |
<0.5ppm after dilution |
|
Ash |
: |
<0.01% |
|
Aromatic compounds |
: |
None |
|
Alkyl phenol ethoxylates |
: |
None |
|
Halogens (measured as total Chlorine) |
: |
<10 ppm for concentrate |
|
pH |
: |
7.5 - 8.5 |
|
Specific gravity |
: |
1.01 |
|
Total alkali metals |
: |
<0.5ppm after dilution |
|
Ash |
: |
<0.01% |
|
Aromatic compounds |
: |
None |
|
Alkyl phenol ethoxylates |
: |
None |
|
Halogens (measured as total Chlorine) |
: |
<10 ppm for concentrate |
|
pH |
: |
7.5 - 8.5 |
|
Specific gravity |
: |
1.01 |
|
Total alkali metals |
: |
<0.5ppm after dilution |
|
Ash |
: |
<0.01% |
|
Aromatic compounds |
: |
None |
|
Alkyl phenol ethoxylates |
: |
None |
|
Halogens (measured as total Chlorine) |
: |
<10 ppm for concentrate |
Appearance
Clear pale straw coloured liquid with a mild pleasant odour.
Solubility
Completely soluble in water. No agitation required.
Compatibility
Not corrosive or detrimental to any of the materials normally used in gas turbine engines or aircraft components. No adverse effect on synthetic turbine oils.
| Product Name | RXSOL-36-1927-220 |
| Product Type | TURBOCLEAN HeavyDuty Hydrocarbon |
Company Details:
RX MARINE INTERNATIONAL
105, A wing , BSEL , TECH PARK.
VASHI ,NEW BOMBAY 400703 INDIA
Stock Point : Mumbai, Kandla, Kolkata, Vizag, Chennai, FUjairah, Muscat, Nairobi
| Phone | +91 22 65113333 / 5555 / 9999 |
| Fax | +91 22 2781 1318 :::AOH :0091 9821214367 |
| care@rxmarine.com |
This product contains no hazardous ingredients ( Blend of non-ionic surfactants, Corrosion Inhibitors, Organic solvents and demineralised water.)
| 2,2',2''-Nitrilotriethanol | 2.5-10% | CAS: 102-71-6 EINECS: 203-049-8 |
| Detergent | 10-20% | Proprietory Blend |
| 2-Methylpentane-2,4-Diol | 2.5-10% | CAS: 107-41-5, EINECS: 203-489-0 |
| Solvent Naphtha, Heavy Aromatic |
25-50% |
CAS: 64742-94-5, EINECS: 265-198-5
CAS: 64742-94-5, EINECS: 265-198-5
|
| 2-Butoxyethanol | 2.5-10% | CAS: 111-76-2 EINECS: 203-905-0 |
|
Non ionic Surfactants Mixture |
2.5-10 % |
Proprietory Blend |
| Oleic Acid | 2.5-10% | CAS: 112-80-1 EINECS: 204-007-1 |
| Skin Contact | Irritant |
| Eye Contact | Irritant |
| Ingestion |
Not toxic by ingestion, may cause mild lung or throat irritation at high concentrations, prolonged or repeated contact may cause drying of skin |
|
INHALATION |
If irritation occurs, remove person to fresh air |
|
EYE CONTACT |
Immediately flush eye with clean water for at least 15 minutes, get medical attention |
|
SKIN CONTACT |
Remove contaminated clothing and shoes, flush area with copious amounts of clean water and soap, seek |
|
INHALATION |
If irritation occurs, remove person to fresh air |
|
INGESTION |
Do NOT induce vomiting, do not give anything by mouth to an unconscious person, seek medical attention immediately |
|
FLASH POINT |
>100°C / 212 °F (PMCC) |
|
CONDITIONS OF FLAMMABILITY |
Non-flammable, water based |
|
EXTINCTION MEDIA |
Use dry chemical, CO2, alcohol-proof foam, sand or fine water spray |
|
FIRE AND EXPLOSION HAZARD |
Oxides of nitrogen, carbon monoxide, carbon dioxide. Fumes are acrid and irritating |
|
METHODS FOR CLEANING UP SMALL SPILLS |
Absorb with sand or vermiculite, sweep up and place in container for later disposal. |
|
METHODS FOR CLEANING UP LARGE SPILLS |
Dike for later salvage or disposal. In water, divert flow to prevent spread of product, remove for disposal |
|
ENVIRONMENTAL PRECAUTIONS |
Do not allow product or run off to enter any sewer or other water source. |
|
HANDLING |
Use in well ventilated area, wear recommended personal protective equipment and wash after handling |
|
STORAGE |
Store in dry, cool well ventilated area out of direct sunlight and away from ignition sources. The product has a shelf life of 5 years. |
|
ENGINEERING MEASURES |
Use mechanical ventilation if used in a confined area or at elevated temperatures |
|
EYES PROTECTION |
Goggles should be worn |
|
HAND PROTECTION |
Impermeable gloves such as butyl rubber, wash after handling |
|
SKIN PROTECTION |
Long sleeves and long pants to prevent skin contact and closed toe footwear to prevent skin contact |
|
PHYSICAL STATE |
Liquid |
|
APPEARANCE |
Clear, Pale straw color |
|
ODOR |
Mild, Pleasant |
|
SPECIFIC GRAVITY |
0.955 |
|
DENSITY |
8.35 lbs/gal |
|
PH |
7.2-7.5 |
|
Flash Point |
> 65 |
|
Ignition Temperature |
≥240ºC |
|
STABILITY |
Product is stable under normal temperature and pressure |
|
MATERIALS TO AVOID |
Product is incompatible with strong oxidizing or reducing agents |
| Skin contact | irritant |
| Eye contact | irritant |
| ingestion |
Not toxic by ingestion, may cause mild lung or throat irritation at high concentrations, prolonged or repeated contact may cause drying of skin |
|
INHALATION |
If irritation occurs, remove person to fresh air |
WATER HAZARD CLASS:- slightly hazardous for water when discharged in large volumes
DISPOSAL :- Dispose of by methods in compliance with local, state and federal regulations.
MOBILITY :- May penetrate the soil as it is biodegradable.
SEWAGE TREATMENT PLANTS :- Not toxic to sewage organisms at concentrations expected to be found in sewage treatment
plants .
N/A
N/A
The above information is believed to be correct but does not purport to be all inclusive and shall be used only as a guide. The information in this document is based on the present state of our knowledge and is applicable to the product with regard to appropriate safety precautions.
DISCLAIMER OF LIABILITY :The information in this SDS was obtained from sources which we believe are reliable. However, the information is provided without any warranty, express or implied, regarding its correctness. The conditions or methods of handling, storage, use or disposal of the product are beyond our control and may be beyond our knowledge. For this and other reasons, we do not assume responsibility and expressly disclaim liability for loss, damage or expense arising out of or in any way connected with the handling, storage, use or disposal of the product. This MSDS was prepared and is to be used only for this product. If the product is used as a component in another product, this MSDS information may not be applicable.