OIL Spill Dispersant Type-II 25 Ltrs

This product is specially designed for complete emulsification of oil by which subsequent dispersion takes place.
Category

The RXSOL-17-1058-025 is the new, 3rd generation dispersant which is the latest water and Surface Active Agent  based formulation oil spill dispersant with no flash point, non toxic and free from petroleum distillate and soluble in sea or fresh water.use as Type II . It can be used concentrated or diluted to a ratio of 1:10 depending on the contamination level. It is an efficient and environmental friendly product containing no hydrocarbons. It has been specifically designed for oil dispersion at sea, it can be applied by spray from booms on work boats, hand sprayers

Application

The RXSOL OIL Spill Dispersant Type II uses non-ionic surfactant formulation with exceptional dispersing strength when applied with agitation can break up oil slicks, grease masses, sludge, general dirt and grime to leave a high clean surface. Suitable for use at sea,docks or in port where petroleum based products are not allowed.
HIGH – EMULSIFICATION rate Converts hydrocarbons particle  in to  very fine emulsions.        Ready to use product. Suitable for Crude  / Bitumen / Residual  / Diesel / Kerosene, White spirit  & Lube oils etc .          Effective  on oil spills at plateform , during loading or discharging of  cargo  or bunkers .              For cleaning of spills on Deck, Ships side, Piers, Wharfs, etc. where allowed .

Dose


The Rxol Oil Spill Dispersant Type - II  to be used  to be used is 1 litre per 15–20 m2 as tested on a spillage of BH crude oil. The Rxsol Oil Spill Dispersant Type II uses non-ionic surfactant formulation with exceptional dispersing strength when applied with agitation can break up oil slicks, grease masses, sludge, general dirt and grime to leave a high clean surface. Suitable for use at sea, docks or in port.

For Use in Sea (Oily Water Surface) : -

By Aerial Spraying

The aircraft using the appropriate form of spraying equipment which has been tested and found satisfactory .may spray Rxsol Oil Spill Dispersant Type II ,over the sea, the product being used neat.

By Boat:
Direct a hard coarse spray surface at the surface of the spill with nozzle pressure of 80 to 100 psi, continually move the stream of water over the spill.


For Use in Oil Spill in case of Fire : -


Handle the same as for dispersing oil spills, moving a narrow coarse spray over burning Oil and fuel  surface. In emergencies, foam pick up nozzles may be used. But air intake at the nozzle should be covered to give a harder stream of water.

For Use in Oil Spill at Shore:-

Wash off the spill by directing a hard course stream of Rxsol Oil Spill Dispersant Type II directly at the surface and rinse off spill. Alternatively, work the dispersant over the spill surface and rinse off with strong jets of water.The quantity of Rxsol Oil Spill Dispersant demanded depends on the size of contamination in the affected area.Repetition of the cleaning process may be necessary, until oil–spill elimination is complete.

On Ship:-

Spray the required quantity of the product, with the appropriate spraying equipment, over the oil spill. After spraying  mix thoroughly using a brush, mop, sponge or any other stirring device feasible to move with rapid and irregular action.Pour water over the treated surface and mix vigorously.Rinse thoroughly by applying high–pressure Machine or any other available source.Repeat cleaning if require necessary.
 

Technical specifications

Note

Feture and Benifit :

 -High dispersion efficiency product
- Avoid the crude oil to end-up on shore
- Simple, quick and efficient answer
 - Efficient dispersion of wide range of oils in a broad range of temperatures,
- High efficiency for cleaning hydrocarbons (oils and other related products)
- For cleaning of hydrocarbons spills on deck, ships side, piers, wharfs, etc., where allowed.
- Cleaning up after spills that may occur during loading of bunkers where allowed.
- Minimizes environmental damage.
- Does not contribute further to pollution.
• Cost effective and economical.
• Easy to handle and apply.


Physical Properties
Appearance / Color :Clear to Slight Yellow liquid
Density (g/ml)          :1.00–1.05 at 20°C
Odor                        :Characteristic ether like odor
Flash Point              :NA
pH                            : 7

Remarks / Precaution

Packing sizes
<br />
MSDS

Product Name RXSOL-17-1058-025
Product Type OIL SPILL DISPERSANT TYPE - II

Company Details:

RX MARINE INTERNATIONAL
105, A wing , BSEL , TECH PARK.
VASHI ,NEW BOMBAY 400703 INDIA

Stock Available in: Mumbai, Kandla, Kolkata, Chennai, Vizag, Fujairah UAE, Muscat Oman, Kenya, Canada

Phone +91 22 65113333 / 5555 / 9999 / 27611360
Fax +91 22 2781 1318 :::AOH :0091 9821214367
Email 123@rxmarine.com

Chemical Name

Concentration

CAS Number

R Phrases*

Symbols

3-Butoxypropanol-2

10-30%

5131-66-8

R36/38

Xi

Sodium Alkene Sulfonate

10-30%

684390-57-6

R36/38

Xi

Sodium Di-octyl Sulphosuccinate

1-10%

577-11-7

R38,R41

Xi

Proprietory ingredient not classified

30-50%

 

 

 

Environmental Hazards

None

Human Health  Hazards

Moderates

NOTE : Person-related safety precautions  Not required

After inhalation

On Inhalation move to fresh air / Arificial respiration . Get medical attention.

After skin contact

Instantly wash with water and soap and rinse thoroughly. Generally Non Irritating , Protective   clothing require

After eye contact

Rinse opened eye for several minutes under running water. If symptoms persist, consult doctor.

After swallowing

Harmful, if ingested,Do not induce Vomiting. Get medical attention.

Extinguishing Media:-

A. Suitable  

Foam ,dry Co2, water spray

B. Not suitable  

Not applicable

C. Special

Not applicable  , Do not use Direct water jet   

Protection of fire Fighter  

Masked with Air Respirator

Care for environmental protection

Prevent material from reaching sewage system, holes and cellars. Dilute with much water.

Procedure  for cleaning/collecting

Remove Rxsol Oil Spill Diapersant Type - II with absorbent materials or mechanically . And dispose accordance with section 13, Then flush with water and ventilate well.

Note

Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust).

Handling   

Eyewash facilities require at workplace

Storage    

General Storage , container should be tightly.

Methods of cleaning   

Flush Spill Area with Water

NOTE

Keep Container Tightly Closed

Enviromental Precaution 

Readily Bio-Degradable,miscible with water,low toxicity,No environmental problem on correct usage.  

PERSONAL  PROTECTION :-

Respiratory System Protection 

Breathing equipment Not required

Eye Protection    

Wear eye protection (on possibility of contact)    

NOTE

The product does not contain any relevant quantities of materials with critical values that have to be monitored at the workplace.Wash hands during breaks and at the end of the work.Avoid contact with the eyes and skin. Keep away from foodstuffs, beverages and food.

PRODUCT PROPERTIES:-

Appearance

Clear liquid / Low viscous  

 

Odor 

Characteristic / Odorless 

 

Density

In g/cm3 at 15°C: 1.00 NOTE : SHELF LIFE  6 YEARS

 

Boiling Point 

MATERIALS BOILS AT 100°C

 

Flash Point

190°C

 

Flammability 

Not self Igniting

 

Explosive

Not Explosive

 

Solubility in Water 

100% soluble  

EFFICIENCY 

Compatibility

 

A.SEA WATER  90%
B.FRESH WATER 98.8 %

Metal

No known effect    

 

pH    

7 +0.5

 

PACKAGING

Order No.Oil Spill Dispersant Type - II  

Size (in litres) 25  , 210  

Condition to Avoid

Heat, Flame & Other Sources of Ignition

Materials  to Avoid

Do not subject to Reducing /Oxidizing Agents.

Hazardous Decomposition Products

Do not occur

NOTE

No decomposition if used according to specifications

Skin Irritation

irritant. wash with soap water

Eye Irritat

Moderate irritant , flush with copious amounts of water

Sensitization   

Not Sensitizing .

                   

Comment   

Not applicable

Ecotoxicity    

Not applicable , Readily biodegradable

Water hazard class 2 (self-assessment):

hazardous for water

Do not allow product to reach ground water, water bodies or sewage system. Danger to drinking water if even small quantities leak into soil.

This material must be disposed with local national regulations.Product Recommendation Can be burnt under adherence to the necessary technical regulations. Disposal must be made according to official regulations

 • Marine pollutant : No
 • Transport/Additional information Not Dangerous.

Hazard designation of product: Xi Irritant. Irritating to eyes and skin. Safety phrases Keep out reach of childre If swallowed, seek medical attention immediately In case of contact with eyes, rinse immediately  with plenty  of water  and  seek medical attention. After contact with skin, wash  immediately with plenty of water and soap and rinse thoroughly.National regulations

These data are based on our present knowledge. However, they shall not constitute a guarantee for any specific product features and shall not establish a legally valid contractual relationship. Department issuing data specification sheet Environment protection department.

DISCLAIMER OF LIABILITY :The information in this SDS was obtained from sources which we believe are reliable. However, the information is provided without any warranty, express or implied, regarding its correctness. The conditions or methods of handling, storage, use or disposal of the product are beyond our control and may be beyond our knowledge. For this and other reasons, we do not assume responsibility and expressly disclaim liability for loss, damage or expense arising out of or in any way connected with the handling, storage, use or disposal of the product. This MSDS was prepared and is to be used only for this product. If the product is used as a component in another product, this MSDS information may not be applicable.

Need a quote for this product?

Tell us the grade, packing and quantity you need — we ship across India and to major ports.

Request a quote office@kolkatachemical.com