Degreaser with unique feature that dissociates slop to separate oil and water. This product is formulated to meet the ever changing regulations for the treatment of tank cleaning waste water after using petroleum based solvents, and Bunker "C" cleaners.
Ideally suited for slop tanks. Also recommended for local cleaning & degreasing of engine rooms, bilges & tank tops. Low toxicity, non - corrosive. Highly effective, economical solvent cleaner.
Sludge Breaker manufacturer and sludge breaker supplier in Mumbai, gandhidham, Chennai, Visakhapatnam, Kakinada, Manglore, Goa, Kolkata, Haldia, Paradip, fujirah, Dubai, Sharjah, UAE, middle East.
RXSOL-20-2006-210 is fast acting demulsifier that is formulated specially to break sludge oil and tight emulsion.
Sludge Breaker soften and break down heavy oils, tar and asphalt sludge deposits and waxing Agent. Also can be used as all purpose degreaser emulsifiers, Specially designed for engine room and cargo tank cleaning . Main feature of RXSOL-20-2006-025 is, it finally dissociate slop emulsion to separate oil and water.This provide us with ability to dispose of waste solution as per MARPOL & IMO rules and regulation
For light contamination dilute with water in the ratio 1:20 . For medium contamination dilute with a petrosolvent. And for heavy contamination concentrated RXSOL-20-2006-0210 is suggested.
For Engine Room & Cargo Tank Cleaner
Dosage:- Dose rate and results will vary depending on amount of contamination . For light contamination dilution with water up to 1:20 is recommended where as medium contamination dilution with Petro solvent , And for heavy contamination neat RXSOL CB 2006 is suggested to use.
Procedure of use :- RXSOL-20-2006-025 is recommended for local cleaning & degreasing of engine rooms, bilges & tank tops. It may be applied by brush, spray, immersion, soaking, or any other conventional means.RXSOL-20-2006-025 is used neat. Allow a residence time of at least 20- 45 minutes where possible, to ensure good penetration & emulsification. Finally wash the system with hot water & high pressure.The emulsion residue after cleaning must be allowed to separate in a holding tank for atleast 3-5 hours before passing through an oily water separator.
Tank Cleaning after Mineral Oils/ Lube Oils / Slope-Black Oil
1 ) Fill the tank with 1-35 litres per ton wash water.Best results are obtained when water is heated to a temperature between 65°C & 80°C then stripped constantly and transferred to a holding tank for separation.The time for this will vary depending on amount of RXSOL-20-2006-025 used & nature of oil being cleaned.Generally,12 hours should be sufficient before the water phase can be removed.
2) Direct Cleaning.Spray directly RXSOL-20-2006-025 on tank surfaces to be cleaned, left for at least 30 minutes.Finally wash with hydrogating (high pressure) machine. Hot water between 50°C & 80°C recommended.
| Product Name | RXSOL-20-2006-0210 |
| Product Type | Chembreak Emulsion Breaker 210 Ltr |
Company Details:
RX MARINE INTERNATIONAL
105, A wing , BSEL , TECH PARK.
VASHI ,NEW BOMBAY 400703 INDIA
| Phone | +91 22 65113333 / 5555 / 9999 |
| Fax | +91 22 2781 1318 :::AOH :0091 9821214367 |
| mail@rxmarine.com |
|
Chemical Name |
Concentration |
CAS Number |
EC Number |
R Phrases* |
Symbols |
|
White spirit (de-aromatized) |
60-100 |
64742-48-9 |
265-150-3 |
65,66 |
Xn |
|
Sodium Petroleum Sulphonate |
5-10 |
68608-26-4 |
271-781-5 |
36 |
Xi |
| Rice Bran Derivative | 20-30 | Proprietory | ------------ | ----------- | ------ |
*See Section 16
|
Odour |
Smells of hydrocarbon. |
|
Appearance |
Liquid, brown, insoluble in water. |
|
Contact with eyes |
Causes redness and irritation. |
|
Contact with skin |
Prolonged skin contact will result in defatting of the skin, leading to irritation, and in some cases, dermatitis. |
|
Inhalation |
In cases of severe exposure, anaesthesia may develop, May cause chronic pneumonitis, May cause coughing. |
|
Ingestion |
Harmful: may cause lung damage if swallowed (R65), The ingestion of significant quantities.may cause nausea/vomiting. |
|
Contact with skin |
Remove contaminated clothing immediately and drench affected skin with plenty of water Contaminated clothing should be laundered before reuse Seek medical attention if irritation persists. |
|
Contact with eyes |
If substance has got into eyes, immediately wash out with plenty of water for at least 15 minutes Irrigate eyes thoroughly whilst lifting eyelids When in doubt or symptoms persist, seek medical attention. |
|
Ingestion |
Do not induce vomiting because of risk of aspiration into the lungs. If aspiration is suspected obtain immediate medical attention If vomiting occurs turn patient on side Obtain immediate medical attention. |
|
Inhalation |
Remove patient to fresh air Seek medical attention if ill effects occur. |
|
General |
In case of accident or if you feel unwell, seek medical advice immediately (show the label where possible) (S45). |
- Auto-ignition point 225 deg C at 760 mm Hg
- Flash point 66 deg C (CC)
- Decomposition products may include carbon oxides
- In case of fire use water spray or fog, alcohol resistant foam, dry chemical or carbon dioxide (S43)
- Do not use water jets
- Prevent run off water from entering drains if possible
- Vapours are heavier than air and may travel considerable distances to a source of ignition and flashback
|
Personal Precautions |
Wear protective clothing as per section 8. |
|
Environmental Precautions |
Do not allow to enter public sewers and watercourses. |
|
Immediate Actions |
Contain spillage by any means possible. |
|
Clean Up Actions |
Absorb spillage in inert material and shovel up Ventilate the area and wash spill site after material pick-up is complete. |
|
Special Precautions |
Do not allow to enter public sewers and watercourses Wear protective clothing as per section 8. |
|
Handling |
Avoid contact with skin and eyes (S24/25) Eyewash bottles should be available See Section 8. |
|
Storage |
Keep only in the original container in a cool, well ventilated place (S3/9/49) Keep container tightly closed (S7) Keep away from open flames, hot surfaces and sources of ignition. |
|
Exposure Limits |
TLV (TWA) 275 mg/m3 (White spirit (de-aromatized). |
|
Exposure controls |
No special ventilation is required unless the product is used in a spray form. |
|
Occupational exposure controls |
No respiratory protection is required unless subject to contact with substance mist During fumigation/spraying wear suitable respiratory equipment (S42) Wear suitable protective clothing, including eye/face protection and gloves (neoprene or nitrile are recommended). |
|
Odour |
Smells of hydrocarbon |
|
Appearance |
Liquid, brown, insoluble in water |
|
pH |
not applicable |
|
Boiling point |
195 °C at 760 mm /Hg |
|
Vapour pressure |
1 mbar |
|
Vapour density |
(air = 1) >1 |
|
Melting point |
not known |
|
Specific gravity |
1.0 |
| Solubility | Insoluble in water |
|
Flash point |
66 deg C (CC) |
|
Auto-ignition point |
225 deg C at 760 mm Hg |
|
Lower explosive limit |
0.6 % (in air) |
- This article is considered stable under normal conditions
- Keep away from naked flames, incandescent or hot surfaces
- See Section 5
|
Toxicological information |
No experimental data available. |
|
Inhalation |
Inhalation of solvent vapours may give rise to nausea, headaches and dizziness. |
|
Contact with skin |
Prolonged skin contact will result in defatting of the skin, leading to irritation, and in some cases, dermatitis. |
|
Contact with eyes |
May cause redness and irritation. |
|
Ingestion |
The ingestion of significant quantities may cause gastro-intestinal disturbances Aspiration hazard. |
|
Carcinogenicity |
No evidence of carcinogenic effects. |
|
Ecotoxicity |
This product has been evaluated on its behaviour in the environment by "The TNO Institue of Environmental Sciences" (The Netherlands organisation for applied Scientific Research). Based upon their report, IMO's BCH Working Group on the Evaluation of Safety and Pollution Hazards approved this product for use as tank cleaning agent by chemical tankers. Naphtha : LC50 (fish) >100 mg/l (96 hr). EC50 (daphnia) >100 mg/l (72 hr). IC50 (algae) >100 mg/l (72 hr) |
|
Mobility |
Insoluble in water |
|
Persistence and Biodegradability |
BOD28/COD > 60% (Naphtha) Sodium petroleum sulphonate: Not readily biodegradable |
|
Bioaccumulation Potential |
No information available |
|
Other Adverse Effects |
No environmental problems are expected when the product is used / handled correctly. In its intended use, the product will not be released into the environment. |
|
Classification |
This material and/or its container must be disposed of as hazardous waste.EU Waste class: 07.01 |
|
Disposal considerations |
Do not discharge into drains or the environment, dispose to an authorised waste collection point Disposal should be in accordance with local, state or national legislation |
- Not classified as hazardous for transport
|
Risk Phrases |
Harmful: may cause lung damage if swallowed (R65).Repeated exposure may cause skin dryness or cracking (R66) |
|
Safety Phrases |
Do not breathe spray/mists (S23) Wear suitable protective clothing, eye/face protection and gloves (S36/37/39) If swallowed, do not induce vomiting: seek medical advice immediately and show this container or label (S62). |
Text of R and S phrase codes used in this safety data sheet:- R36: Irritating to eyes; R65: Harmful: may cause lung damage if swallowed; R66: Repeated exposure may cause skin dryness or cracking.The information provided about the product on this Safety Data Sheet has been compiled from knowledge of the individual constituents The data given here is based on current knowledge and experience. This Safety Data Sheet describes the product in terms of safety requirements and does not signify any warranty with regard to the product's properties The data given here only applies when product used for proper application(s). The product is not sold as suitable for other applications - usage in such may cause risks not mentioned in this sheet. Do not use for other application(s) without seeking advice from manufacturer.This Safety Data Sheet is provided in compliance with The Dangerous Substances Directive (67/548/EEC).This Safety Data Sheet is provided in compliance with The Dangerous Preparations Directive (88/379/EEC).This Safety Data Sheet is provided in compliance with The Safety Data Sheets Directive (2001/58EC).Composition information in accordance with Regulation (EC) No 648/2004 of the European Parliament and of the Council of 31 March 2004 on detergents:Aliphatic hydrocarbons >30 %
Anionic surfactants 5-15 %
DISCLAIMER OF LIABILITY :The information in this SDS was obtained from sources which we believe are reliable. However, the information is provided without any warranty, express or implied, regarding its correctness. The conditions or methods of handling, storage, use or disposal of the product are beyond our control and may be beyond our knowledge. For this and other reasons, we do not assume responsibility and expressly disclaim liability for loss, damage or expense arising out of or in any way connected with the handling, storage, use or disposal of the product. This MSDS was prepared and is to be used only for this product. If the product is used as a component in another product, this MSDS information may not be applicable.