AntiFouling Preventing Liquid is a very effective clear, yellowish green with anti fungal based dispersing cleaner for the control of fouling by marine growth such as algae, shellfish, mussels, barnacles and micro-organisms and fungal growth in the sea water side of coolings systems. Due to its moleculer firm foaming properties, it also acts as a corrosion inhibitor.
COMMON NAME : BIOLOGICAL GUARD
It should be preferably be started on a clean system since it is formulated to prevent growth rather than remove existing growth of microorganism < bacteria , fungi , larvae etc.. ( EXISTING GROWTH CAN BE CLEAN BY USING RXSOL-11-1008--DC / RXSOL-54-1008-SA )
The best POINT of feeding is as early as possible in the system , preferably at the suction point of strainer , this will helps dispersion of solution in all parts of the sewater cooling system.
# Effectively control MICROORGANISM GROWTH
# Economical , reduce down time cost , also doesn't require any special monitoring
# Also control biological corrosion
For sea water cooling systems
Dose 150 – 500 ML of RXSOL-40-4003-025 for every 100 tons of sea water flowing through the system per hour. The treatment should be applied daily when the vessel is on coastal waters. Normally the treatment is not required when sailing deep sea .
For ballast tanks
Dose 1 litre of RXSOL-40-4003-025 per 10 tons of water prior to ballasting, followed by a monthly dose of 2 litres per 100 tons.
For Trim Tanks, Oil Rig Sea Legs and Similar Systems
Dose 25 litres of RXSOL-40-4003-025 per 100 tons of water . GENERAL Testing for bacteria can be done with our RXSOL DIP SLIDE METHODS ( Designed to check and see anytime anywhere invisible danger Bacteria / fungus grow from Cooling / Drinking water ) which indicate the extent of the bacteriological contamination.
1 . Avoid to use in any food area / food crop ( FARMING PURPOSE ).
2 . It is strongly recommended to clean entire fouled contaminated system prior to its use .
3. IT SHOULD ONLY BE DILUTED WITH FRESH WATER .
4. Causes eye and skin irritation , WORKERS must wear all chemical resistant apron and face mask , long pants , shoes. Strictly avoid contamination of food items.
| Product Name | : | RXSOL-40-4003-025 |
| Product Type | : | BIOLOGICAL GUARD |
Company Details:
RX MARINE INTERNATIONAL
105, A wing , BSEL , TECH PARK.
VASHI ,NEW BOMBAY 400703 INDIA
Stock Point : Mumbai, Kandla, Kolkata, Chennai, Visakhapatnam, Fujairah, Muscat
| Phone | : | +91 22 65113333 / 5555 / 9999 / 27611360 |
| Fax | : | +91 22 2781 1318 :::AOH :0091 9821214367 |
| : | care@rxmarine.com |
|
Chemical Name |
Concentration |
CAS Number |
EC Number |
R Phrases* |
Symbols |
|
Amines, N-tallowalkyl Trimethylendiacetates |
5 - 10 % |
68911-78-4 |
272-786-5 |
22, 34, 50 |
C, N |
|
2-Butoxyethanol |
5 - 10 % |
111-76-2 |
203-905-0 |
20/21/22, 36/38 |
Xn |
|
Amines, N-tallow Alkylpropylenedi |
10 - 15 % |
64742-94-5 |
265-198-5 |
65, 66, 51, 53 |
Xn, N |
| Ethanediol | 60-100 % | 107-21-1 | 203-473-3 | R22 | Xn |
| N-Coco-1,3-Diaminopropane | 10-24 % | 61791-63-7 | 263-195-3 | R22-35-48/25-50 | C ,T ,N |
*See Section 16
|
Odour |
Characteristic odour |
|
Appearance |
Liquid, pale yellow, soluble in water |
|
Contact with eyes |
Risk of serious damage to eyes (R41) |
|
Contact with skin |
Causes irritation |
|
Inhalation |
Harmful by inhalation, in contact with skin and if swallowed (R20/21/22).Very toxic to aquatic organisms (R50) |
|
Contact with skin |
Remove contaminated clothing immediately and drench affected skin with plenty of water. Then wash with soap and water.When in doubt or symptoms persist, seek medical attention Contaminated clothing should be laundered before reuse |
|
Contact with eyes |
If substance has got into eyes, immediately wash out with plenty of water for at least 15 minutes Irrigate eyes thoroughly whilst lifting eyelids. Seek immediate medical attention.Continue flushing with water until medical help arrives |
|
Ingestion |
Never make an unconscious person vomit or drink fluids.Give plenty of water to drink.Do not induce vomiting.Seek immediate medical attention |
|
Inhalation |
Remove patient to fresh air.Keep warm and at rest, in a half upright position. Loosen clothing.When in doubt or symptoms persist, seek medical attention |
|
General |
In case of accident or if you feel unwell, seek medical advice immediately (show the label where possible) (S45) |
- Flash point >70 deg C (CC)
- Decomposition products may include phosgene, Decomposition products may include carbon oxides
- In case of fire use water spray or fog, alcohol resistant foam, dry chemical or carbon dioxide (S43)
- Substance evolves toxic fumes, wear self-contained breathing apparatus
- Prevent run off water from entering drains if possible
- Use water spray or fog to knock down and absorb corrosive fumes
- Vapours are heavier than air and may travel considerable distances to a source of ignition and flashback
|
Personal Precautions |
Wear protective clothing as per section 8.Vapours are heavier than air and may travel considerable distances to a source of ignition and flashback. |
|
Environmental Precautions |
Do not allow to enter public sewers and watercourses. |
|
Immediate Actions |
Use appropriate containment to avoid environmental contamination (S57) |
|
Clean Up Actions |
Absorb spillage in inert material and shovel up.Ventilate the area and wash spill site after material pick-up is complete. |
|
Special Precautions |
Wear protective clothing as per section 8. Avoid release to the environment. Refer to special instructions/Safety data sheets (S61).Vapours are heavier than air and may travel considerable distances to a source of ignition and flashback. |
|
Handling |
See Section 8.Eyewash bottles should be available.Avoid contact with skin and eyes (S24/25) |
|
Storage |
Keep only in the original container in a cool, well ventilated place (S3/9/49) |
|
Exposure Limits |
TLV (TWA) 20 ppm, 122 mg/m3 (1,2-Dichlorobenzene). |
|
Exposure controls |
The undiluted product must not be used in a confined space without good ventilation. |
|
Occupational exposure controls |
Wear approved respirator if exposure likely to exceed MEL/OES.Wear goggles giving complete eye protection.Wear suitable protective clothing, including eye/face protection and gloves (neoprene or nitrile are recommended). |
Gloves Suit Goggles No_Smoking
|
Odour |
Unpleasant odour, Strong smell of phenol |
|
Appearance |
Liquid, brown, dispersible in water |
|
pH |
10 -11 (5% in 50/50 H2O-IPA mix) |
|
Boiling point > |
100 °C at 760 mm /Hg |
|
Vapour pressure |
not known |
|
Vapour density |
(air = 1) >01 |
|
Freezing point |
0 °C at 760 mm/Hg |
|
Insoluble in water |
|
|
Specific gravity |
(water=1) 1.02 |
|
Flash point > |
70 deg C (CC) |
- This article is considered stable under normal conditions, May cause rubber to swell
- Avoid overheating
- Incompatible with strong oxidizing substances, Contact with alkaline earth metals may form explosive
gases, Contact with alkali metals may form explosive gases
- See Section 5
|
Toxicological information |
No experimental data available Inhalation.Vapours or aerosols may cause irritation of eyes, nose and respiratory tract. |
|
Contact with skin |
In cases of severe exposure, redness and irritation may develop. |
|
Contact with eyes |
Causes irritation |
|
Ingestion |
May cause gastro-intestinal disturbances. |
|
Carcinogenicity |
No evidence of carcinogenic effects. |
|
Ecotoxicity |
This product does not contain ingredients which are classified in the EU as dangerous for the environment. |
|
Mobility |
Completely soluble in water |
|
Persistence and Biodegradability |
Its main ingredients will either dissolve rapidly and dissociate in water or are readily/inherently biodegradable. |
|
Bioaccumulation Potential |
Bioaccumulation of the components in this product is insignificant. Other Adverse Effects.No environmental problems are expected when the product is used / handled correctly. |
|
Classification |
This material and/or its container must be disposed of as hazardous waste EU Waste class |
|
Disposal considerations |
Do not discharge into drains or the environment, dispose to an authorised waste collection point. Disposal should be in accordance with local, state or national legislation. |
|
Proper Shipping Name |
||||
|
UN |
|
|
|
|
|
|
Proper Shipping Name |
Environmentall yhazardous substance, liquid, n.o.s. (contains alkyl propylenediamine) |
||
|
|
UN NO |
3082 |
|
|
|
|
Hazard Class |
9 |
Packing Group |
III |
|
Road/Rail (ADR/RID) |
||||
|
|
Proper Shipping Name |
Environmentally hazardous substance, liquid, n.o.s. (contains alkyl propylenediamine) |
||
|
|
ADR UN No |
3082 |
|
|
|
|
ADR Hazard Class |
9 |
Termcard |
9-01 |
|
Sear (IMDG) |
||||
|
|
Proper Shipping Name |
Environmentally hazardous substance, liquid, n.o.s. (contains alkyl propylenediamine) |
||
|
|
IMDG UN No |
3082 |
|
|
|
|
IMDG Hazard Class |
9 |
IMDG Pack Group |
II |
|
|
IMDG EmS |
F-A, S-B |
IMDG subrisk |
- |
|
IMDG Labels |
9 |
IMDG Flashpoint |
- |
|
|
Air(ICAO/IATA) |
||||
|
|
Proper Shipping Name |
Environmentally hazardous substance, liquid, n.o.s. (contains alkyl propylenediamine) |
||
|
|
ICAO UnNo |
3082 |
|
|
|
|
ICAO Hazard Class |
9 |
ICAO Packing Group |
II |
|
|
ICAO subrisk |
- |
ICAO Labels |
9 |
|
|
ICAO Flash point |
- |
|
|
|
DOT/CFR (USD epartment of Transportation |
||||
|
|
DOT Proper Shipping Name: |
Environmentally hazardous substance, liquid, n.o.s. (contains alkyl propylenediamine) |
||
|
|
Hazardous Material |
see section 2 |
|
|
|
|
Hazard Class: |
9 |
Identification Number: |
UN 3082 |
|
|
Product RQ (lbs): |
N/A |
DOT subrisk: |
- |
|
|
DOT Labels: |
9 |
DOT Flash point: |
- |
|
Risk Phrases |
Irritating to eyes (R36). |
|
Safety Phrases Irritant |
In case of contact with eyes, rinse immediately with plenty of water and seek medical advice (S26). Wear suitable gloves and eye/face protection (S37/39). |
Text of R and S phrase codes used in this safety data sheet:- R34: Causes burns; R36: Irritating to eyes; R37: Irritating to respiratory system; R41: Risk of serious damage to eyes. The information provided about the product on this Safety Data Sheet has been compiled from knowledge of the individual constituents The data given here is based on current knowledge and experience. This Safety Data Sheet describes the product in terms of safety requirements and does not signify any warranty with regard to the product's properties The data given here only applies when product used for proper application(s). The product is not sold as suitable for other applications - usage in such may cause risks not mentioned in this sheet. Do not use for other application(s) without seeking advice from manufacturer
DISCLAIMER OF LIABILITY :The information in this SDS was obtained from sources which we believe are reliable. However, the information is provided without any warranty, express or implied, regarding its correctness. The conditions or methods of handling, storage, use or disposal of the product are beyond our control and may be beyond our knowledge. For this and other reasons, we do not assume responsibility and expressly disclaim liability for loss, damage or expense arising out of or in any way connected with the handling, storage, use or disposal of the product. This MSDS was prepared and is to be used only for this product. If the product is used as a component in another product, this MSDS information may not be applicable.