Bilge Coat (Sulphur Acid Neutralizer)
RXSOL Bilge Coat is highly effective chemicals and an alkaline Solution for the Bilge Line and well during the carry of cargo as like Sulphur. This Product act as a neutrilizer for the collection of Acidic Bilge Water. Bilge coat is more safer and effective in use compare than other alkaline Materials.
Acts as Acid Neutralizer formed during sulphur voyages.
Dose and Using Procedure
• Use a clean Drum or any plastic tank. Fill the water up to 190 Ltrs and add the RXSOL concentrated Bilge coat 2-4 Ltrs. Stirr well and now it is ready RXSOL BILGE COAT SOLUTION to use.
• Pour 15 to 20 litres of RXSOL BILGE COAT SOLUTION directly into each hold sounding pipe from on deck. Replenish each time after the bilge water is pumped out.
General recommandation 1 Jug per hold, per week.
OCCURS OR SYMPTOMS PERSIST.
| INTENDED USE |
DILUTION RATE (Concentrate : Fresh Water) |
BOXES PER HOLD |
HANDYMAX (per week) |
PANAMAX (per week) |
| Bilge Water (Acidic Water) Neutralizer | 1 : 23 (4 ltrs : 92 ltrs water) | 20-25 Ltrs | 100 Ltrs | 125 Ltrs |
Benifit :
>Bilge Protection against Acidic Water.
>Enviroment Friendly.
>Low quantity is sufficiant Due to High Concentration and easy ro transport.
>Can be Easly Use and make the solution by Ship Crew on board.
> Due to liquid easy to handle and safe compare than other solid alkaline materials.
- Avoid contact with skin and eyes. Avoid breathing mist
- and vapors. Always wear protective gloves, goggles
- and masks. Keep away from oxidizers, acids and
-
metallic powders. Refer to MSDS for more information.
FIRST AID MEASURES
SKIN : Wash exposed areas with water.
EYES : Flush eyes with plenty of water for 20 mins.
INHALATION : Remove patient to fresh air.
INGESTION : Do not induce vomiting.
Give patient a glass of water or milk.
GET MEDICAL ATTENTION IF ALLERGIC REACTION
| Product Name | RXSOL-22-2209-025 |
| Product Type | Bilge Coat (Sulphur Acid Neutralizer) |
Company Details:
RX MARINE INTERNATIONAL
105, A wing , BSEL , TECH PARK.
VASHI ,NEW BOMBAY 400703 INDIA
Stock Point : Mumbai, Kandla, Kolkata, Chennai, Paradip, Vizag, Fujairah, Muscat, Nairobi
| Phone | +91 22 65113333 / 5555 / 9999 / 27611360 |
| Fax | +91 22 2781 1318 :::AOH :0091 9821214367 |
| mail@rxmarine.com |
|
Chemical Name |
Percent |
Cas Number |
Symbol |
|
Hydroxide solution mixture |
42 -45 |
--------------- |
C |
|
Ingrident not Classified as Dangerous good |
48-55 |
---------------- |
|
|
Potential Health Effects:- |
|
|
Inhalation |
Severe irritant. Effects from inhalation of dust or mist vary from mild irritation to serious damage of the upper respiratory tract, depending on severity of exposure. Symptoms may include sneezing, sore throat or runny nose. Severe pneumonitis may occur. |
|
Ingestion |
Corrosive! Swallowing may cause severe burns of mouth, throat, and stomach .Severe scarring of tissue and death may result. Symptoms may include bleeding, vomiting diarrhea, fall in blood pressure. Damage may appears days after exposure. |
|
Skin Contact |
Corrosive! Contact with skin can cause irritation or severe burns and scarring with greater exposures. |
|
Eye Contact |
Corrosive! Causes irritation of eyes, and with greater exposures it can cause burns that may result in permanent impairment of vision, even blindness. |
|
Chronic Exposure |
Prolonged contact with dilute solutions or dust has a destructive effect upon tissue. Aggravation of Pre-existing Conditions: Persons with pre-existing skin disorders or eye problems or impaired respiratory function may be more susceptible to the effects of the substance. |
|
Inhalation |
Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Call a physician. |
|
Ingestion |
Do Not Induce Vomiting! Give large quantities of water or milk if available. Never give anything by mouth to an unconscious person. Get medical attention immediately. |
|
Skin Contact |
Immediately flush skin with Soap and plenty of water for at least 15 minutes while removing contaminated clothing and shoes. Call a physician, immediately. Wash clothing before reuse. |
|
Eye Contact |
Immediately flush eyes with plenty of water for at least 15 minutes, lifting lower and upper eyelids occasionally. Get medical attention immediately. |
|
Fire |
Not considered to be a fire hazard. Hot or molten material can react violently with water. Can react with certain metals, such as aluminum, to generate flammable hydrogen gas. |
|
Explosion |
Not considered to be an explosion hazard. |
|
Fire Extinguishing Media |
Use any means suitable for extinguishing surrounding fire. Adding water to caustic solution generates large amounts of heat. |
Ventilate area of leak or spill. Keep unnecessary and unprotected people away from area of spill. Wear appropriate personal protective equipment as specified in Section 8. Spills: Pick up and place in a suitable container for reclamation or disposal, using a method that does not generate dust. No Emergancy Result From Soliage But spil lShould be clean up Prompotly . Residues from spills can be diluted with water.Clean up spill as using observent materials .
Keep in a tightly closed container. Protect from physical damage. Store in a cool, dry,ventilated area away from sources of heat, moisture and incompatibilities. Always add the Bilge Coat in to water while stirring; never the reverse. observe all warnings and precautions listed for the product. Do not store with aluminum or magnesium.
Avoi Avoid Contact with eyes and prolonged skin contact. Avoid breathing dusts, vapors, mists or gases. Wash thoroughly after handling and before eating, drinking, or smoking.Do not mix with acids or organic materials.
|
OSHA Permissible Exposure Limit (PEL) |
2 mg/m3 Ceiling – ACGIH |
|
Threshold Limit Value (TLV) |
2 mg/m3 Ceiling |
|
Ventilation System |
A system of local and/or general exhaust is recommended to keep employee exposures below the Airborne Exposure Limits. Local exhaust ventilation is generally preferred because it can control the emissions of the contaminant at its source, preventing dispersion of it into the general work area. |
|
Personal Respirators |
If the exposure limit is exceeded, a half-face dust/mist respirator may be worn for up to ten times the exposure limit or the maximum use concentration specified by the appropriate regulatory agency or respirator supplier, whichever is lowest. A full-face piece dust/mist respirator may be worn up to 50 times the exposure limit, or the maximum use concentration specified by the appropriate regulatory agency, or respirator supplier, whichever is lowest. For emergencies or instances where the exposure levels are not known, use a full-face piece positive-pressure, air-supplied respirator. |
|
WARNING |
Air-purifying respirators do not protect workers in oxygen-deficient atmospheres. |
|
Skin Protection |
Wear impervious protective clothing, including boots, gloves, lab coat, apron or coveralls, as appropriate, to prevent skin contact. |
|
Eye Protection |
Use chemical safety goggles and/or a full face shield where splashing is possible. Maintain eye wash fountain and quick-drench facilities in work area. |
|
Appearance |
Clear to Yellow |
|
Odor |
Odorless |
|
Solubility |
100% |
|
pH |
13 |
|
Specific Gravity |
2.3 g/ml |
|
Boiling Point |
138 º C |
|
Freezing Point |
-30 º C |
|
Vapor Pressure (mm Hg) |
Negligible |
|
Evoporation Rate (BuAc = 1) |
No information found |
|
Stability |
Stable under ordinary conditions of use and storage. |
|
Hazardous Decomposition Products |
Sodium Hydroxide. Decomposition by reaction with certain metals releases flammable and explosive hydrogen gas. |
|
Hazardous Polymerization |
Will not occur. |
|
Incompatibilities |
Contact with water, acids, flammable liquids, and organic halogen compounds, especially trichloroethylene, may cause fire or explosion. Contact with nitromethane and other similar nitro compounds causes formation of shock-sensitive salts. Contact with metals such as aluminum, tin, and zinc causes formation of flammable hydrogen gas. |
|
Skin Irritation |
irritant, wash with soap water |
|
Eye Irritat |
Moderate irritant , flush with copious amounts of water |
|
Sensitization |
Not Sensitizing . |
(All above information as per data available with us)
|
Comment |
Not applicable |
|
Ecotoxicity |
Not applicable , Readily biodegradable |
This material must be disposed with local national regulations. Product Recommendation ( Recommended cleaning agent: water ) Can be burnt under adherence to the necessary technical regulations. Disposal must be made according to official regulations.Can be reused or recycled after cleaning .
- Marine pollutant: No
- Transport/Additional information
• Irritating to eyes and skin.
• Safety phrases - Keep out reach of children
If swallowed, seek medical attention immediately
22 Harmful if swallowed
26 In case of contact with eyes, rinse immediately with plenty of water and
seek medical attention.
23 Do not Breathe
27 After contact with skin, wash immediately with plenty of water and soap and rinse thoroughly.
41 Risk of serious damage to eyes
These data are based on our present knowledge. However, they shall not constitute a guarantee for any specific product features and shall not establish a legally valid contractual relationship.Department issuing data specification sheet Environment protection department.Note : No Enviromental Problems Are Expected If The Product Is Handled Correctly.
DISCLAIMER OF LIABILITY :The information in this SDS was obtained from sources which we believe are reliable. However, the information is provided without any warranty, express or implied, regarding its correctness. The conditions or methods of handling, storage, use or disposal of the product are beyond our control and may be beyond our knowledge. For this and other reasons, we do not assume responsibility and expressly disclaim liability for loss, damage or expense arising out of or in any way connected with the handling, storage, use or disposal of the product. This MSDS was prepared and is to be used only for this product. If the product is used as a component in another product, this MSDS information may not be applicable.