Removes alginate loose plaster and stone.
Category
MSDS
| Porduct Name | Alginate Remover Powder |
| Part Number | RXSOL-10-3006-009 |
Company Details:
RX MARINE INTERNATIONAL
105, A wing , BSEL , TECH PARK.
VASHI ,NEW BOMBAY 400703 INDIA
Branch : Kandla, Mumbai , Chennai, Vizag, Kolkata, UAE , OMAN , CANADA and KENYA
| Phone | +91 22 20871200 - 1400 |
| Fax | +91 22 27612100 :::AOH :0091 9821214367 |
| mail@rxmarine.com | |
| Website | www.rxmraine.com |
| Chemical Name | Cas No | EC No | Whight | Formula |
| Melamine | 108-78-1 | 203-615-4 | 126,12 g/mol | C3H6N6 |
| Signal Word | Danger |
| Hazard Statements | H351 Suspected of causing cancer. H361f Suspected of damaging fertility. H373 May cause damage to organs (Urinary tract) through prolonged or repeated exposure. |
| Precautionary statements | Do not handle until all safety precautions have been read and understood. P260 Do not breathe dust. P280 Wear protective gloves/ protective clothing/ eye protection/ face protection. P308 + P313 IF exposed or concerned: Get medical advice/ attention. P405 Store locked up. P501 Dispos |
| Classification of the substance or mixture | none |
| Supplemental Hazard Statements | None |
| Other hazards | none |
| General advice | Show this material safety data sheet to the doctor in attendance. |
| If inhaled | After inhalation: fresh air. Call in physician. |
| Eye Contact | After eye contact: rinse out with plenty of water. Call in ophthalmologist. Remove contact lenses. |
| Swallowed | After swallowing: immediately make victim drink water (two glasses at most). Consult a physician. |
| Skin Contact | In case of skin contact: Take off immediately all contaminated clothing. Rinse skin with water/ shower. Consult a physician. |
| Inhalation | Remove patient to fresh air, keep warm and at rest and get medical assistance in necessary. |
| Ingestion | Rinse mouth with water. Do not induce vomiting. Never give anything by mouth to an unconscious person. Call a doctor or Poison Control Center immediately. |
| Most important symptoms and effects, both acute and delaye | The most important known symptoms and effects are described in the labelling (see section 2.2) and/or in section 11 |
| Indication of any immediate medical attention and special treatment needed | No data available |
| Suitable extinguishing media | Water Foam Carbon dioxide (CO2) Dry powder |
| Unsuitable extinguishing media | For this substance/mixture no limitations of extinguishing agents are given |
| Special hazards arising from the substance or mixture | Carbon oxides Nitrogen oxides (NOx) Hydrogen bromide gas Combustible. Development of hazardous combustion gases or vapours possible in the event of fire |
| Further information | Suppress (knock down) gases/vapors/mists with a water spray jet. Prevent fire extinguishing water from contaminating surface water or the ground water system. |
|
Hazardous combustion products |
Fire may cause the evolution of Sulphur oxides, nitrogen oxides. |
| Advice for firefighters | Stay in danger area only with self-contained breathing apparatus. Prevent skin contact by keeping a safe distance or by wearing suitable protective clothing. |
| Protective Equipment | Use personal protective equipment. |
| Specific Hazards Arising from the Chemical | No data available |
| Personal precautions, protective equipment and emergency procedures | Advice for non-emergency personnel: Avoid inhalation of dusts. Avoid substance contact. Ensure adequate ventilation. Evacuate the danger area, observe emergency procedures, consult an expert. |
| Spillage | No data available |
| Personal Protection | No data available |
| Enviromental Precaution | Do not let product enter drains.. |
|
Methods and materials for containment and cleaning |
Cover drains. Collect, bind, and pump off spills. Observe possible material restrictions (see sections 7 and 10). Take up dry. Dispose of properly. Clean up affected area. Avoid generation of dusts. |
| Reference to other sections | For disposal see section 13. |
| Advice on protection against fire and explosion | Work under hood. Do not inhale substance/mixtureable |
| Incompatible materials | No data available. |
| Hygiene measures | Immediately change contaminated clothing. Apply preventive skin protection. Wash hands and face after working with substance. |
| Advice on safe handling | For precautions see section 2.2. |
| Conditions for safe storage, including any incompatibilities | No data available. |
| Storage conditions | Tightly closed. Dry. hygroscopic |
| Storage class | Storage class (TRGS 510): 11: Combustible Solids |
| Specific end use(s) | Apart from the uses mentioned in section 1.2 no other specific uses are stipulated |
| Advice on general occupational hygiene | No data available |
| Exposure controls | No specific additional engineering controls are required. Provide good natural or artificial ventilation. |
| Engineering Control | Handle in accordance with good industrial hygiene and safety practice. Wash hands before breaks and at the end of workday. |
| Eye/face protection | Use equipment for eye protection tested and approved under appropriate government standards such as NIOSH (US) or EN 166(EU). Safety glasses |
| Body Protection | protective clothing |
| Skin protection | This recommendation applies only to the product stated in the safety data sheet, supplied by us and for the designated use. When dissolving in or mixing with other substances and under conditions deviating from those stated in EN374 please contact the supplier of CE-approved gloves (e.g. KCL GmbH, D-36124 Eichenzell, Internet: www.kcl.de). Full contact Material: Nitrile rubber Minimum layer thickness: 0,11 mm Break through time: 480 min Material tested:KCL 741 Dermatril® L This recommendation applies only to the product stated in the safety data sheet, supplied by us and for the designated use. When dissolving in or mixing with other substances and under conditions deviating from those stated in EN374 please contact the supplier of CE-approved gloves (e.g. KCL GmbH, D-36124 Eichenzell, Internet: www.kcl.de). Splash contact Material: Nitrile rubber Minimum layer thickness: 0,11 mm Break through time: 480 min Material tested:KCL 741 Dermatril® L |
| Respiratory protection |
required when dusts are generated. Our recommendations on filtering respiratory protection are based on the following standards: DIN EN 143, DIN 14387 and other accompanying standards relating to the used respiratory protection system. Recommended Filter type: Filter type P3 The entrepeneur has to ensure that maintenance, cleaning and testing of respiratory protective devices are carried out according to the instructions of the producer. These measures have to be properly documented.
|
| Other Protection Measure | Handle in accordance with good industrial hygiene and safety practice. |
| Control of environmental exposure | Do not let product enter drains. |
| Physical state | powder |
| Colour | white |
| Odour | odorless |
| Odor Threshold | Not Applicable |
| pH | 6,48 at 30 °C |
| Melting Point | > 300 °C - lit |
| Boiling Point | 144,3 °C |
| Flash Point | 6 °C - closed cup |
| Evaporation Rate | Not Applicable |
| Flammability (solid, gas) | May form combustible dust concentrations in air. |
| Explosive limits | No Data Available |
| Upper/lower flammability or explosive limits | No data available |
| Autoignition temperature | No data available |
| Decomposition temperature | No data available |
| Vapour pressure | No data available |
| Viscosity | No data available |
| Density | 0,523 g/cm3 at 30,5 °C |
| Relative Density | No data available |
| Specific Gravity | No data available |
| Partition coefficient | No data available |
| Explosive properties | No data available |
| Solubility | No data available |
| Ignition temperature | No information available. |
| Particle characteristics | No data available |
| Reactivity | Forms explosive mixtures with air on intense heating. A range from approx. 15 Kelvin below the flash point is to be rated as critical. The following applies in general to flammable organic substances and mixtures: in correspondingly fine distribution, when whirled up a dust explosion potential may generally be assumed |
| Chemical stability | The product is chemically stable under standard ambient conditions (room temperature) . |
| Possibility of hazardous reactions | Violent reactions possible with: Strong oxidizing agents Strong acids |
| Conditions to avoid | Strong heating. |
| Incompatible materials |
No data available
|
| Hazardous decomposition products | In the event of fire: see section 5 |
| Acute toxicity | LD50 Oral - Rat - female - > 300 - 2.000 mg/kg (OECD Test Guideline 423) Inhalation: No data available LD50 Dermal - Rat - male and female - > 2.000 mg/kg (OECD Test Guideline 402) |
| Skin corrosion/irritation | Skin - Rabbit Result: Skin irritation (OECD Test Guideline 404) |
| Serious eye damage/irritation | Eyes - Rabbit Result: Irritations (OECD Test Guideline 405) |
| Respiratory or skin sensitization | Buehler Test - Guinea pig Result: negative (OECD Test Guideline 406) |
| Carcinogenicity | No data available |
| Germ cell mutagenicity | Test Type: Ames test Test system: Escherichia coli/Salmonella typhimurium Metabolic activation: with and without metabolic activation Method: OECD Test Guideline 471 |
| Reproductive toxicity | Suspected of damaging the unborn child. Suspected of damaging fertility |
| Specific target organ toxicity - single exposure |
No data available
|
| Additional Information | The substance/mixture does not contain components considered to have endocrine disrupting properties according to REACH Article 57(f) or Commission Delegated regulation (EU) 2017/2100 or Commission Regulation (EU) 2018/605 at levels of 0.1% or higher.. |
| Persistence and degradability | No data available |
| Toxicity to fish | static test LC50 - Danio rerio (zebra fish) - > 100 mg/l - 96 h (OECD Test Guideline 203) |
| Toxicity to daphnia and other aquatic invertebrates | semi-static test EC50 - Daphnia magna (Water flea) - 50 mg/l - 48 h (OECD Test Guideline 202) |
| Toxicity | Toxicity to fish LC50 - Pimephales promelas (fathead minnow) - 1.520 mg/l - 96 h |
| Toxicity to bacteria | EC50 - Vibrio fischeri - 1,862 mg/l - 0,25 h Remarks: (ECHA) |
| Toxicity to algae | static test ErC50 - Chlorella vulgaris (Fresh water algae) - 204,7 mg/l - 72 h (OECD Test Guideline 201) |
| Products Biodegradation | The methods for determining the biological degradability are not applicable to inorganic substances. |
| Mobility in soil | No data available |
| Results of PBT and vPvB assessment | This substance/mixture contains no components considered to be either persistent, bioaccumulative and toxic (PBT), or very persistent and very bioaccumulative (vPvB) at levels of 0.1% or higher. |
| Endocrine disrupting properties | No data available |
| Other adverse effects | No data available . |
| Product | No data available . |
| Contaminated packaging | No data available . |
| Waste treatment Method | No data available . |
| UN number | ADR/RID: IMDG: IATA: |
| UN proper shipping name |
ADR/RID: Not dangerous goods IMDG: Not dangerous good IATA: Not dangerous goods |
| Transport hazard class(es) | ADR/RID: IMDG: IATA: |
| Packaging group | ADR/RID: IMDG: IATA: |
| Environmental hazards | ADR/RID: IMDG: IATA: |
| Special precautions for user | No data available |
| Further information | Not classified as dangerous in the meaning of transport regulations. |
| Safety, health and environmental regulations/legislation specific for the substance or mixture | This material safety data sheet complies with the requirements of Regulation (EC) No. 1907/2006. |
| Other regulations | Observe work restrictions regarding maternity protection in accordance to Dir 92/85/EEC or stricter national regulations where applicable. Take note of Dir 94/33/EC on the protection of young people at work. |
| Chemical Safety Assessment | For this product a chemical safety assessment was not carried out |
| Other Information |
The information above is believed to be accurate and represents the best information currently available to us. However, we make no warranty of merchantability or any other warranty, express or implied, with respect to such information, and weassume no liability resulting from its use. Users should make their own investigations to determine the suitability of the information for their particular purposes. In no event shall be liable for any claims, losses, or damages of any third party or for lost profits or any special, indirect, incidental, consequential or exemplary damages, howsoever arising, even if Rx Marine International has been advised of the possibility of such damages. DISCLAIMER OF LIABILITY :The information in this SDS was obtained from sources which we believe are reliable. However, the information is provided without any warranty, express or implied, regarding its correctness. The conditions or methods of handling, storage, use or disposal of the product are beyond our control and may be beyond our knowledge. For this and other reasons, we do not assume responsibility and expressly disclaim liability for loss, damage or expense arising out of or in any way connected with the handling, storage, use or disposal of the product. This MSDS was prepared and is to be used only for this product. If the product is used as a component in another product, this MSDS information may not be applicable. |
| No data available |
| No data available |
| No data available |
| No data available |