The RXSOL-17-1058-025 is the new, 3rdgeneration dispersant which is the latest water and Surface Active Agent based formulation oil spill dispersant with no flash point, non toxic and free from petroleum distillate and soluble in sea or fresh water.use as Type II . It can be used concentrated or diluted to a ratio of 1:10 depending on the contamination level. It is an efficient and environmental friendly product containing no hydrocarbons. It has been specifically designed for oil dispersion at sea, it can be applied by spray from booms on work boats, hand sprayers or hoses using an injector.
This product is specially designed for complete emulsification of oil by which subsequent dispersion takes place.
The Rxsol OIL Spill Dispersant Type II uses non-ionic surfactant formulation with exceptional dispersing strength when applied with agitation can break up oil slicks, grease masses, sludge, general dirt and grime to leave a high clean surface. Suitable for use at sea,docks or in port where petroleum based products are not allowed.
HIGH – EMULSIFICATION rate Converts hydrocarbons particle in to very fine emulsions. Ready to use product. Suitable for Crude / Bitumen / Residual / Diesel / Kerosene, White spirit & Lube oils etc . Effective on oil spills at plateform , during loading or discharging of cargo or bunkers . For cleaning of spills on Deck, Ships side, Piers, Wharfs, etc. where allowed .
The Rxol Oil Spill Dispersant Type - II to be used to be used is 1 litre per 15–20 m2 as tested on a spillage of BH crude oil. The Rxsol Oil Spill Dispersant Type II uses non-ionic surfactant formulation with exceptional dispersing strength when applied with agitation can break up oil slicks, grease masses, sludge, general dirt and grime to leave a high clean surface. Suitable for use at sea, docks or in port.
For Use in Sea (Oily Water Surface) : -
By Aerial Spraying
The aircraft using the appropriate form of spraying equipment which has been tested and found satisfactory .may spray Rxsol Oil Spill Dispersant Type II ,over the sea, the product being used neat.
By Boat:
Direct a hard coarse spray surface at the surface of the spill with nozzle pressure of 80 to 100 psi, continually move the stream of water over the spill.
For Use in Oil Spill in case of Fire : -
Handle the same as for dispersing oil spills, moving a narrow coarse spray over burning Oil and fuel surface. In emergencies, foam pick up nozzles may be used. But air intake at the nozzle should be covered to give a harder stream of water.
For Use in Oil Spill at Shore:-
Wash off the spill by directing a hard course stream of Rxsol Oil Spill Dispersant Type II directly at the surface and rinse off spill. Alternatively, work the dispersant over the spill surface and rinse off with strong jets of water.The quantity of Rxsol Oil Spill Dispersant demanded depends on the size of contamination in the affected area.Repetition of the cleaning process may be necessary, until oil–spill elimination is complete.
On Ship:-
Spray the required quantity of the product, with the appropriate spraying equipment, over the oil spill. After spraying mix thoroughly using a brush, mop, sponge or any other stirring device feasible to move with rapid and irregular action.Pour water over the treated surface and mix vigorously.Rinse thoroughly by applying high–pressure Machine or any other available source.Repeat cleaning if require necessary.
Feture and Benifit :
-High dispersion efficiency product
- Avoid the crude oil to end-up on shore
- Simple, quick and efficient answer
- Efficient dispersion of wide range of oils in a broad range of temperatures,
- High efficiency for cleaning hydrocarbons (oils and other related products)
- For cleaning of hydrocarbons spills on deck, ships side, piers, wharfs, etc., where allowed.
- Cleaning up after spills that may occur during loading of bunkers where allowed.
- Minimizes environmental damage.
- Does not contribute further to pollution.
• Cost effective and economical.
• Easy to handle and apply.
Physical Properties
Appearance / Color :Clear to Slight Yellow liquid
Density (g/ml) :1.00–1.05 at 20°C
Odor :Characteristic ether like odor
Flash Point :NA
pH : 7
| Product Name | RXSOL-17-1058-025 |
| Product Type | OIL SPILL DISPERSANT TYPE - II |
Company Details:
RX MARINE INTERNATIONAL
105, A wing , BSEL , TECH PARK.
VASHI ,NEW BOMBAY 400703 INDIA
Stock Point : Mumbai, Kandla, Kolkata, Chennai, Visakhapatnam, Fujairah, Muscat
| Phone |
 +91 22 27815540 / 41 |
| Fax |
+91 22 2781 1318 :::AOH :0091 9821214367 |
| mail@rxmarine.com |
|
Chemical Name |
Concentration |
CAS Number |
R Phrases* |
Symbols |
|
3-Butoxypropanol-2 |
10-30% |
5131-66-8 |
R36/38 |
Xi |
|
Sodium Alkene Sulfonate |
10-30% |
684390-57-6 |
R36/38 |
Xi |
|
Sodium Di-octyl Sulphosuccinate |
1-10% |
577-11-7 |
R38,R41 |
Xi |
|
Ingrident not classified |
30-50% |
|
|
|
|
Environmental Hazards |
None |
|
Human Health Hazards |
Moderates |
NOTE : Person-related safety precautions Not required
|
After inhalation |
On Inhalation move to fresh air / Arificial respiration . Get medical attention. |
|
After skin contact |
Instantly wash with water and soap and rinse thoroughly. Generally Non Irritating , Protective clothing require |
|
After eye contact |
Rinse opened eye for several minutes under running water. If symptoms persist, consult doctor. |
|
After swallowing |
Harmful, if ingested,Do not induce Vomiting. Get medical attention. |
Extinguishing Media:-
|
A. Suitable |
Foam ,dry Co2, water spray |
|
B. Not suitable |
Not applicable |
|
C. Special |
Not applicable , Do not use Direct water jet |
|
Protection of fire Fighter |
Masked with Air Respirator |
|
Care for environmental protection |
Prevent material from reaching sewage system, holes and cellars. Dilute with much water. |
|
Procedure for cleaning/collecting |
Remove Rxsol Oil Spill Diapersant Type - II with absorbent materials or mechanically . And dispose accordance with section , Then flush with water and ventilate well. |
|
Note |
Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust). |
|
Handling |
Eyewash facilities require at workplace |
|
Storage |
General Storage , container should be tightly. |
|
Methods of cleaning |
Flush Spill Area with Water |
|
NOTE |
Keep Container Tightly Closed |
|
Enviromental Precaution |
Readily Bio-Degradable,missible with water,low toxicity,No environmental problem on correctly usage. |
PERSONAL PROTECTION :-
|
Respiratory System Protection |
Breathing equipment Not required |
|
Eye Protection |
wear eye protection (on possibility of contact) |
|
NOTE |
The product does not contain any relevant quantities of materials withcritical values that have to be monitored at the workplace.Wash hands during breaks and at the end of the work.Avoid contact with the eyes and skin. Keep away from foodstuffs, beverages and food. |
PRODUCT PROPERTIES:-
|
Appearance |
Clear liquid / Low viscous |
|
|
Odor |
Characteristic / Odorless |
|
|
Density |
In g/cm3 at 15°C: 1.00 NOTE : SHELF LIFE 6 YEARS |
|
|
Boiling Point |
MATERIALS BOILS AT 100°C |
|
|
Flash Point |
190°C |
|
|
Flammability |
Not self Igniting |
|
|
Explosive |
Not Explosive |
|
|
Solubility in Water |
100% soluble |
EFFICIENCY |
|
Compatibility |
|
A.SEA WATER 90% |
|
Metal |
No known effect |
|
|
pH |
7 +0.5 |
|
|
PACKAGING |
Order No.Oil Spill Dispersant Type - II |
Size (in litres) 25 , 210 |
|
Condition to Avoid |
Heat, Flame & Other Sources of Ignition |
|
Materials to Avoid |
Do not subject to Reducing /Oxidizing Agents. |
|
Hazardous Decomposition Products |
Do not occur |
|
NOTE |
No decomposition if used according to specifications |
|
Skin Irritation |
irritant. wash with soap water |
|
Eye Irritat |
Moderate irritant , flush with copious amounts of water |
|
Sensitization |
Not Sensitizing . |
|
Comment |
Not applicable |
|
Ecotoxicity |
Not applicable , Readily biodegradable |
|
Water hazard class 2 (self-assessment): |
hazardous for water |
|
Do not allow product to reach ground water, water bodies or sewage system. Danger to drinking water if even small quantities leak into soil. |
|
This material must be disposed with local national regulations.Product Recommendation Can be burnt under adherence to the necessary technical regulations. Disposal must be made according to official regulations
• Marine pollutant : No
• Transport/Additional information Not Dangerous.
Hazard designation of product: Xi Irritant. Irritating to eyes and skin. Safety phrases Keep out reach of childre If swallowed, seek medical attention immediately In case of contact with eyes, rinse immediately with plenty of water and seek medical attention. After contact with skin, wash immediately with plenty of water and soap and rinse thoroughly.National regulations
These data are based on our present knowledge. However, they shall not constitute a guarantee for any specific product features and shall not establish a legally valid contractual relationship. Department issuing data specification sheet Environment protection department.
DISCLAIMER OF LIABILITY :The information in this SDS was obtained from sources which we believe are reliable. However, the information is provided without any warranty, express or implied, regarding its correctness. The conditions or methods of handling, storage, use or disposal of the product are beyond our control and may be beyond our knowledge. For this and other reasons, we do not assume responsibility and expressly disclaim liability for loss, damage or expense arising out of or in any way connected with the handling, storage, use or disposal of the product. This MSDS was prepared and is to be used only for this product. If the product is used as a component in another product, this MSDS information may not be applicable.